risk management – business analysis – কুইজ মডেল টেস্ট অনুশীলন – 18

risk-management – business-analysis – কুইজ মডেল টেস্ট অনুশীলন – 18

risk management | 1461. You need to make changes to a new router. By which prompt is the global configuration mode on this router identified?

1. Router(config-router)#
2. Router(config)#
3. Router#
4. Router(config-line)#

1462. What will a new router do during startup if a configuration file is not located in NVRAM?

1. It will search for the configuration file in flash and if no configuration file is found there
2. it will enter the setup dialogIt will search for the configuration file in the locations specified by boot system commands.It will search for the configuration file on a TFTP server and if no configuration file is found there
3. it will enter the setup dialogIt will search for the configuration file in flash and if no configuration file is found there
4. it will load a limited configuration file from ROM.”;}}

1463. Which of the following commands would be applied to a WAN interface, but not on LAN Interface?

1. no shutdown
2. None of the above
3. IP address
4. encapsulation PPP

1464. After making some network changes you power off and then power on your Cisco router named PC1. What sequence of events occurs when PC1 is powered up?

1. Test software routines
2. POST
3. load configuration files
4. load Cisco IOS software

1465. Why might the network administrator set the configuration register to 0x2142 on a 2600 series Cisco router?

1. To upload a new version of the configuration file
2. To boot the IOS from ROM
3. To upload a new version of the IOS
4. To reset the console password

1466. As a trainee you are required to set the default gateway on a Cisco switch to the IP address of 192.168.1.115. Which IOS command should you use?

1. Switch(config)# ip default-gateway 192.168.1.115
2. Switch(config)# ip default-network 192.168.1.115
3. Switch(config)# ip route-default 192.168.1.115
4. Switch(config)# ip route 192.168.1.115 0.0.0.0

1467. The command ip route 192.168.100.160 255.255.255.224 192.168.10.2 20 was issued on a router. No routing protocols or other static routes are configured on the router. Which statement is true about this command?

1. Packets that are destined for host 192.168.100.190 will be sent to 192.168.10.2.
2. The number 20 indicates the number of hops to the destination network
3. The interface with IP address 192.168.10.2 is on this router.
4. The command sets a gateway of last resort for the router.

1468. Which IOS user EXEC command will allow a network technician to determine which router in the path to an unreachable network host should be examined more closely for the cause of the network failure?

1. B > show ip route
2. B> telnet
3. B > trace
4. B > ping

1469. After logging into a router, you type in “enable” and then enter the correct password when prompted. What is the current router prompt symbol at this point?

1. #
2. >
3. ?
4. *

1470. Which is the correct fallback sequence for loading the Cisco IOS?

1. ROM
2. Flash
3. NVRAMFlash
4. TFTP server

আমাদের কাছে থাকা লক্ষ লক্ষ মডেল টেস্ট থেকে প্রাকটিজের জন্য কিছু এখানে তুলে ধরা হল। প্রতিটি অধ্যায়ের উপরে ইশিখন.কম কুইজ চ্যালেঞ্জ এ আছে শত শত মডেল টেস্ট বার বার মডেল টেস্ট দিয়ে নিজেকে যাচাই কর এবং পুরো বাংলাদেশের সকল শিক্ষার্থীর সাথে আপনার মেধা তালিকা দেখুন। প্রশ্নে কোন প্রকার ভুল থাকলে সঠিক উত্তরসহ নিচে কমেন্ট করে জানাবেন, আমরা ঠিক করে দেবো।